1

The toolbar with the most common actions

2

The output folder. This is where you can select a folder from disk where the manipulated images should be stored, once processed.

3

(Click button 10 to see the settings panel)

Specify what version place holder version should be used if the image being processed is part of a version set. If there is no version for the specified place holder, then IDimager will use the selected image (not the main version!).

4

(Click button 10 to see the settings panel)

Select this option if you want to store the current selection of images to the batch design too.

5

(Click button 10 to see the settings panel)

Select this option if you want the output images to be stored as a version of the original in the catalog database. When enabled you can specify to what version placeholder the newly created version should be stored in.

6

The selection of images that will be processed by the Batch Processor.

7

This is the list of all available effects and commands that are available to be added to the batch design.

8

This is the list of all selected effects and commands that will be applied once the batch is started. It is possible to add the same effect and/or command multiple times.

9

(Click button 10 to see the settings panel)

When this setting is enabled then the output images will automatically be imported to the catalog.

10

Click this button to expand or collapse the settings panel